Step 3 Specifying Destinations - Xerox ApeosPort-II 5010 User Manual

The following shows the reference section for each feature.
"General Settings" (P.129)
"Layout Adjustment" (P.133)
"Transmission Options" (P.138)
"Advanced Features" (P.154)

Step 3 Specifying Destinations

Three methods are available to specify recipients: by phone number, by address
number, and by group dial number. The following shows input methods supported by
each method.
Phone Number
Address Number
(Speed Dialing)
Group Dial Number
Important • When using the Server Fax feature, you cannot specify address numbers using the numeric
You can specify multiple recipients (Broadcast Send) using the above methods. You
can also use a combination of the methods.
If the same recipient was specified for several pending documents, you can send the
documents with a single phone call. This feature is referred to as Batch Send. Note that
you cannot use Batch Send with Broadcast Send, Relay Broadcast, Remote Mailbox,
and Delayed Start when prior to the specified time. When using a redial, resend, or
delayed start send transmission job, or authentication feature, to send to the same
address from different users, then Batch Send is not possible.
Important • Confirm the recipient before sending a fax.
For information on Broadcast Send, refer to "Broadcast Send (Transmitting to Multiple Recipients)"
(P.158).
This section describes how to enter a phone number with the numeric keypad.
1
Enter a fax number using the
numeric keypad.
Numeric Keypad
O
3 digits (001 to 500)
∗
2 digits + (nn0 to nn9)
∗∗∗
(All address numbers)
# + 2 digits
keypad or use one-touch buttons.
Fax Procedure
One Touch
Address Book
buttons
X
From the list tab and
3 digits (001 to 070)
index
X
O: Available X: Not available
1 2 3
4 5 6
7 8 9
0 #
C
X
O
4
Numeric keypad
109