Xerox ApeosPort-II 5010 User Manual page 572

16 Appendix
Active Area
Determining
Command
Paper Margin
Image
Enhancement
Stapling
16
Manual Feed
Tray Check
Indicator
Punching
Number of holes
570
161 0 (Default): Auto
1: PS
2: IW
3: IP
4: Adapted
When auto-scaling is in use, this sets the method for obtaining the active
coordinate area.
[Auto]...Determines any of the methods listed below: PS, IW, IP, or
Adapted.
[PS]...Area specified by the first PS command is to be a rectangular area.
[IW]...Area specified by the very last IW command is to be a rectangular
area.
[IP]...Area which combines all the IP commands is to be a rectangular
area.
[Adapted]...The maximum/minimum coordinates within the areas and
coordinates plotted using the drawing command, and the maximum size
of characters and line width specified in the page, are used to calculate
the rectangular area.
162 0 to 99 (Default): 0): 0 - 99 mm
Sets the paper margin when auto scaling is being used.
163 0: OFF
1 (Default): ON
Sets whether to artificially increase the resolution of an image and smooth
its edges.
164 0 (Default): None
1: Top Left
2: Top Double
3: Top Right
4: Left Double
5: Right Double
6: Bottom Left
7: Bottom Double
8: Bottom Right
9: Center
Sets the stapling position.
165 0: None
1 (Default): Yes
166 0: None
1 (Default): Top
2: Bottom
3: Left
4: Right
Sets the punch position.
167 0 (Default): 2 holes
1: 3 holes
2: 4 holes
Sets the number of punch holes.