Step 3 Starting The Scan Job - Xerox ApeosPort-II 5010 User Manual

5 Scan

Step 3 Starting the Scan Job

1
Press the <Start> button.
Important • If the document has been set
Note
If you have more documents
If you have more documents to scan, select [Next Original] on the touch screen while
the current document is being scanned. This allows you to scan the documents as a
single set of data.
Up to 999 pages can be stored.
Note
2
While documents are being
scanned, select [Next Original].
Note
5
3
Load the next document.
4
Press the <Start> button.
If you have more documents, repeat Steps 3 and 4.
5
When all documents have been
scanned, select [Last Original].
176
in the document feeder, do not
hold down the document while
it is being conveyed.
• Scanning cannot be
performed if a copy protection
code is detected.
• If a problem occurs, an error
message appears in the touch
screen. Solve the problem in accordance with the message.
• The next scan job can proceed while scanning.
• If the number of document pages exceeds the maximum, then scanning stops. Follow the
displayed message, and either abort the operation, or save the scanned data.
• When the screen on the right
is displayed and no operation
is performed during a certain
period of time, the machine
automatically assumes that
there are no more documents.
• When using the document feeder, load the next document after the machine has finished
scanning the first document.
• You can change the scan settings of the next document by selecting the [Change Settings]
button that is displayed after selecting [Next Original].
1 2 3
4 5 6
7 8 9
0
#
C
<Start> button