Xerox ApeosPort-II 5010 User Manual page 504

15 Problem Solving
Error Code
C P F S M O
065-210
065-211
065-212
065-213
065-215
065-216
065-219
065-220
071-210
071-211
072-210
072-211
073-210
073-211
074-210
074-211
15
077-211
077-213
112-700
116-324
116-701
O O
116-702
116-703
* If the error persists after following the listed solution, contact our Customer Support Center. The contact number is
printed on the label or card attached on the machine.
502
Category
O [Cause]
[Remedy] Contact our Customer Support Center.
O [Cause]
[Remedy] Power-cycle the machine. If the problem persists, contact
O [Cause]
[Remedy] Contact our Customer Support Center.
O [Cause]
[Remedy] Contact our Customer Support Center. Trays other than
O [Cause]
[Remedy] Contact our Customer Support Center. Trays other than
O [Cause]
[Remedy] Contact our Customer Support Center. Trays other than
O [Cause]
[Remedy] Contact our Customer Support Center. Trays other than
O [Cause]
[Remedy] Contact our Customer Support Center.
O [Cause]
[Remedy] Contact our Customer Support Center.
O [Cause]
[Remedy] Empty the hole punch container.
For more information, refer to "Emptying the Hole Punch Container (When
C-Finisher or C-Finisher with Booklet Maker is Installed)" (P.416).
O [Cause]
[Remedy] Turn off the machine once, then hold down both the
[Cause]
[Remedy] Add memory.
O [Cause]
[Remedy] Check the print data.
O [Cause]
[Remedy] Either check the print data, or click [Spool Settings] on the
Cause and Remedy
An error occurred with the machine.
An error occurred with the document feeder.
our Customer Support Center.
The document feeder is defective.
Tray 1 malfunction
the Tray 1 can be used.
Tray 2 malfunction
the Tray 2 can be used.
Tray 3 malfunction
the Tray 3 can be used.
Tray 4 malfunction
the Tray 4 can be used.
A different type of paper tray is attached.
A different type of Duplex Kit is attached.
The finisher's hole punch container is full.
An error occurred on the machine.
<Start> and <Stop> buttons simultaneously for 6 seconds
when turning the machine back on. This will delete the
print data which caused the error.
Unable to use the 2-sided printing feature due to
insufficient memory.
A print job was processed using a substitute font.
An error occurred during PostScript (optional) processing.
[Details] tab in the print driver to set bi-directional
communication to off.