Xerox ApeosPort-II 5010 User Manual page 554

16 Appendix
Extended Settings
Setting Item
Paper position
Output quantity
Reduce/enlarge
16
2 Up mode
552
Item
Number
20 Sets the paper position.
[0] (Default)
[1]
Note •When a continuous form paper is selected for [Original Size], [Paper
8 Sets the number of copies to be printed.
[1 to 250] (Default: 1): 1-250 copies
Important •When the output quantity is specified by a client, the copies of that set
54 Sets the print magnification.
(Reduce/ [0] (Default)
enlarge mode) [1]
[2]
[Preset %] is a magnification calculated automatically based on [Original
Size] and [Paper Size], and reduces/enlarges the printable area of the
original to fit to the printable area of the output paper. Therefore, if the
size of the original and that of the output paper are the same, the
magnification will be 100%. Also, if [2 Up] is selected, the original will be
reduced to the size where two pages fit into one sheet of paper.
[Variable %] is a magnification set in [Variable %] under [Reduce/
Enlarge]. A reference point for scaling (reducing/enlarging) is the upper
left corner of the printable area. This reference point applies to all text,
images, and graphics.
[Fit to Cut Sheet] prints the entire cut sheet area to the printable area of
the output paper. It is a magnification calculated automatically based on
[Original Size] and [Paper Size], and reduces/enlarges the whole original
(including the area outside of the printable area) to fit to the printable
area of the output paper.
17 Sets the magnification for the vertical or horizontal direction.
(Variable %/ [45 to 210] (Default:100):45-210%
vertical
Note •When a continuous form paper is selected for [Original Size], both
magnification)
18
(Variable %/
horizontal
magnification)
21 Sets whether to print in 2 Up or page by page. 2 Up is a feature that
prints two pages onto one sheet of paper. Depending on the paper
orientation, the two pages are printed side by side, or one above the
other.
[0] (Default)
[1]
[2]
Important •When [Landscape] is selected for [Original Size], [Forward] or
Value
: Without cut sheet feeder (left)
: With cut sheet feeder (center)
Position] cannot be set.
of number will be printed. After printing, the number set on the
control panel will be changed to that number. However, the number
of copies specified from NetWare or lpd port will not change the
number set on the control panel.
: Preset %
: Variable %
: Fit to Cut Sheet
[Preset %] and [Fit to Cut Sheet] produce the same print result.
: Off
: Reverse
: Forward
[Reverse] produce the same print result.