Xerox ApeosPort-II 5010 User Manual page 571

Print Quantity 115
Setup
HP-GL Mode 150
Hard Clip 151
Eject Command 152 (SP)
153 (SPO)
154 (NR)
155 (FR)
156 (PG)
157 (AF)
158 (AH)
Scaling 159
Scaling Mode 160
0 (Default): Protocol
1: Panel
2: Command
Sets the method for specifying the print quantity.
0 (Default): HP-GL
1: HP-GL/2
A graphics language can be selected.
0: Standard
2 (Default): Paper
Sets the size for the area where drawings can be made (hard clip area).
[Standard]...Hard clip area for A4, A3, letter, and ledger are the same as
for the Hewlett Packard HP7550A. Hard clip area for other paper sizes is
the same as this M/C printable area.
[Paper]...Make the hard clip area the same area as the paper.
0 (Default): OFF
1: ON
Sets the command that indicates a drawing is finished. When the
command specified here is received, drawing is terminated and the paper
is ejected.
[Off]...Does not process as an eject command.
[On]...Processes as an eject command.
ON is set as the default for SPO only.
0: OFF
1 (Default): ON
Determines the setting to either enlarge or reduce the document size so
that the document size fits the paper size.
[OFF]...Prints in the same size without enlargement/reduction, even if the
document size and paper size are different.
[ON]...Prints while enlarging/reducing the data on document size so that it
fits the paper size.
0 (Default): Paper Size
1: Active Coordinate Area
Determines how the document size and the paper size are determined
when Document Size (the item number 101) and/or Paper Size (102) is
set to Auto (99).
[Paper Size]...Make the document size the minimum size that combines
the active coordinate area from the active coordinate determining method
and the active coordinate obtained by the settings of Origin Position and
Paper Margin.
[Active Coordinate Area]...Make the document size the area from which
the paper margin is subtracted from the active coordinate area obtained
by the active coordinate determining method.
HP-GL2 Emulation
16
569