Show Services Tcp-Udp - Cisco 220 Series Smart Plus Reference Manual

System Management Commands

show services tcp-udp

show services tcp-udp
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
To show information about the active TCP and UDP services, use the show
services tcp-udp Privileged EXEC mode command.
Syntax
show services tcp-udp
Parameters
N/A
Default Configuration
N/A
Command Mode
Privileged EXEC mode
Example
switchxxxxxx# show services tcp-udp
Type Local IP address
---- ----------------------------- ----------------------------- -------- --
------------
tcp *:80
tcp6 *-80
tcp *:443
tcp6 *-443
udp *:546
udp6 *-546
udp *:546
udp6 *-546
udp *:5353
udp6 *-5353
The following table describes the significant fields shown in the example:
Field Description
Type Protocol type of the service.
Local IP IP address and port number of the local end of the socket.
Address
Remote IP address
*:*
*-*
*:*
*-*
*:*
*-*
*:*
*-*
*:*
*-*
36
Service State
http LISTEN
http LISTEN
https LISTEN
https LISTEN
bonjour
bonjour
457