Rmon Event - Cisco 220 Series Smart Plus Reference Manual

RMON Commands

rmon event

rmon event
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
Command Mode
Global Configuration mode
Example
switchxxxxxx(config)# rmon alarm 1000 interface gi11 collisions 10 delta
rising 100 1 falling 20 2 startup rising owner public
To configure a RMON event, use the rmon event Global Configuration mode
command.
To delete a RMON event, use the no form of this command.
Syntax
rmon event index {log | trap
DESCRIPTION
] [owner
index
no rmon event
Parameters
index
• —The event index. (Range: 1 to 65535)
• log—Specifies that a notification entry is generated in the log table by the
switch for this event.
COMMUNITY
• trap
or more management stations by the switch for this event.
COMMUNITY
• log trap
and an SNMP trap is sent to one or more management stations by the
switch for this event.
DESCRIPTION
• description
this event. (Length: 0 to 127 characters)
NAME
• owner —(Optional) Specifies the name of the person who configured
this event.
COMMUNITY | log trap
NAME
]
—Specifies that an SNMP trap community is sent to one
—Specifies that an entry is generated in the log table
—(Optional) Specifies the comment describing
COMMUNITY } [description
30
378