Table of Contents
Advertisement
IPv6 MLD Snooping Commands
ipv6 mld profile
ipv6 mld profile
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
Follow these guidelines when configuring the MLD throttling action:
•
If you configure the throttling action as deny and set the maximum group
limitation, the entries that were previously in the forwarding table are not
removed but are aged out. After these entries are aged out, when the
maximum number of entries in the forwarding table is reached, the switch
drops the next MLD report received on the interface.
•
If you configure the throttling action as replace and set the maximum group
limitation, the entries that were previously in the forwarding table are
removed. When the maximum number of entries in the forwarding table is
reached, the switch replaces a randomly selected multicast entry with the
received MLD report.
Example
switchxxxxxx(config)# interface gi1
switchxxxxxx(config-if)# ipv6 mld max-groups 25
switchxxxxxx(config-if)# ipv6 mld max-groups action replace
To create a MLD profile and enter the MLD Profile Configuration mode, use the
ipv6 mld profile Global Configuration mode command. From this mode, you can
specify the configuration of the IGMP profile to be used for filtering MLD
membership reports from a switch port.
To delete a MLD profile, use the no form of this command.
Syntax
profile-number
ipv6 mld profile
profile-number
no ip igmp profile
Parameters
profile-number
•
Default Configuration
No IGMP profiles are defined.
—The MLD profile number. (Range:1 to 128)
19
279
Advertisement
Table of Contents
