Table of Contents
Advertisement
Ethernet Configuration Commands
show interface status
show interface status
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
Example
switchxxxxxx# show errdisable recovery
ErrDisable Reason
--------------------------+---------------
bpduguard | disabled
selfloop | disabled
broadcast-flood | disabled
unknown-multicast-flood | disabled
unicast-flood | disabled
psecure-violation | disabled
dhcp-rate-limit | disabled
arp-inspection | disabled
Timer Interval : 300 seconds
Interfaces that will be enabled at the next timeout:
Port |
Error Disable Reason
-----+--------------------------+------------
To show the status for all interfaces or for a specific interface, use the show
interface status Privileged EXEC Mode command.
Syntax
show interface status [
Parameters
interface-id
•
—(Optional) The interface ID or a list of interface IDs. The
interface ID can be one of these types: Ethernet port or port channel.
Command Mode
Privileged EXEC Mode
Default Configuration
N/A
| Timer Status
acl | disabled
| Time Left
interface-id
]
11
164
Advertisement
Table of Contents
