Table of Contents
Advertisement
IGMP Snooping Commands
profile range
profile range
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
Command Mode
Global Configuration mode
User Guidelines
You can execute the command before the VLAN is created.
You can register an entry without specifying an interface.
Example
switchxxxxxx(config)# ip igmp snooping vlan 1 forward-all interfaces fa11
switchxxxxxx(config)# ip igmp snooping vlan 1 forward-all interfaces gi1
switchxxxxxx(config)# ip igmp snooping vlan 1 forward-all interfaces po1
To create an IGMP profile, use the profile range IGMP-profile Configuration mode
command.
Syntax
ip-range
profile range ip
Parameters
ip-range
•
ip
—Specifies a range of IPv4 addresses. This can be a single IPv4
address or a range of addresses. When entering a range, enter the low IPv4
multicast address, a space, and the high IPv4 multicast address.
•
action permit—Permits the matching addresses.
•
action deny—Denies the matching addresses.
Default Configuration
N/A
Command Mode
IGMP-profile Configuration mode
Example
action {permit | deny}
13
216
Advertisement
Table of Contents
