Table of Contents
Advertisement
Power over Ethernet (PoE) Commands
power inline
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
The Power over Ethernet (PoE) feature is only available on the PoE-based
switches.
To configure the inline power administrative mode on an interface, use the power
inline Interface Configuration mode command.
Syntax
power inline {auto | never}
Parameters
•
auto —Turns on the device discovery protocol and applies power to the
device.
•
never —Turns off the device discovery protocol and stops supplying power
to the device.
Default Configuration
The default is auto.
Command Mode
Interface Configuration (Ethernet) mode
Example
The following example turns on the device discovery protocol on port 4:
switchxxxxxx(config)# interface gi4
switchxxxxxx(config-if)# power inline auto
25
358
Advertisement
Table of Contents
