Chapter 10: Eee Commands; Eee Enable (Interface) - Cisco 220 Series Smart Plus Reference Manual

EEE Commands

eee enable (Interface)

Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
To enable the EEE mode on an Ethernet interface, use the eee enable Interface
Configuration mode command.
To disable the EEE mode on an Ethernet interface, use the no form of this
command.
Syntax
eee enable
no eee enable
Parameters
N/A
Default Configuration
EEE is enabled.
Command Mode
Interface Configuration (Ethernet) mode
Example
switchxxxxxx(config)# interface gi1
switchxxxxxx(config-if)# eee enable
Enabling or disabling EEE will cause the port first link down and then up.
Are you sure to proceed? [yes/no]:
10
154