Monitor Session Destination Remote-Span - Cisco 220 Series Smart Plus Reference Manual

Port Monitor Commands

monitor session destination remote-span

monitor session destination remote-span
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
• The port cannot be source port.
• The port is not a member in the port channel.
• GVRP is not enabled on the port.
Example
The following example defines the destination port fa24 for the monitor session 1:
switchxxxxxx(config)# monitor session 1 destination interface gi24
To start a destination interface for remote SPAN, use the monitor session
destination remote-span Global Configuration mode command.
To stop a destination interface for remote SPAN, use the no form of this command.
Syntax
session-number
monitor session
interface-id
interface
session-number
no monitor session
Parameters
session-number
•
vlan-id
• vlan —Specifies the remote VLAN for a RSPAN destination session.
(Range: 2 to 4094)
• reflector-interface
interface ID must be an Ethernet port.
Command Mode
Global Configuration mode
destination remote-span vlan
destination remote-span
—The identifier of the monitor session. (Range: 1 to 4)
interface-id —Specifies the reflector interface ID. The
27
vlan-id
reflector-
373