Using Telnet Over An Ethernet Interface; Cli Command Conventions - Cisco 220 Series Smart Plus Reference Manual

Introduction

CLI Command Conventions

STEP 1
STEP 2
CLI Command Conventions
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x

Using Telnet over an Ethernet Interface

Telnet provides a method of connecting to the command-line interface over an IP
network.
To establish a Telnet session from the command prompt, perform the following
steps:
Click Start, then select All Programs > Accessories > Command Prompt to open a
command prompt.
At the prompt, enter telnet <IP address of switch>, then press Enter.
The command-line interface is displayed.
There are certain command entry standards that apply to all commands. The
following table describes the command conventions:
[ ] In a command line, square brackets indicate an
optional entry.
1
30