Table of Contents
Advertisement
IP ARP Inspection Commands
show ip arp inspection statistics
show ip arp inspection statistics
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
The following table describes the significant fields shown in the example:
Field
Interfaces
Trust State
Rate (pps)
To show the ARP Inspection statistics for all VLANs or for specific VLANs, use the
show ip arp inspection statistics Privileged EXEC mode command.
Syntax
show ip arp inspection statistics [VLAN
Parameters
VLAN-LIST—
•
(Optional) Specifies a VLAN ID or a list of VLAN IDs. (Range: 1
to 4094)
Command Mode
Privileged EXEC mode
Example
switchxxxxxx# show ip arp inspection statistics vlan 1
Vlan| Forward |Source MAC Failures|Dest MAC Failures|SIP Validation
Failures|DIP Validation Failures|IP-MAC Mismatch Failures
Description
Port or LAG on which ARP Inspection trust mode can
be enabled.
Shows whether ARP Inspection trust mode is enabled
or disabled on the interface.
•
Enabled—The port or LAG is a trusted interface,
and ARP inspection is not performed on the
ARP requests and replies sent to and from the
interface.
•
Disabled—The port or LAG is not a trusted
interface, and ARP inspection is performed on
the ARP requests and replies sent to and from
the interface. This is the default value.
Maximum rate that is allowed on the interface.
VLAN-LIST
]
15
244
Advertisement
Table of Contents
