Police - Cisco 220 Series Smart Plus Reference Manual

QoS Commands

police

police
NOTE
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
Syntax
match access-group
no match access-group
Parameters
• access-group
based ACL, or IPv6-based ACL.
Default Configuration
No match criterion is supported.
Command Mode
Class-Map Configuration mode
Example
The following example defines a class map called Class1. Class1 contains an ACL
called enterprise. Only traffic matching all criteria in enterprise belongs to the
class map.
switchxxxxxx(config)# class-map class1
switchxxxxxx(config-cmap)# match access-group enterprise
To define a policer for classified traffic, use the police Policy-map Class
Configuration mode command. This command defines another group of actions
for the policy map (per class map).
To remove a policer, use the no form of this command.
This command is used after the policy-map and class commands.
This command is available only when the switch is in QoS advanced mode.
Syntax
committed-rate-kbps
police
no police
acl-name
acl-name
acl-name
—Specifies the name of a MAC-based ACL, IPv4-
[exceed-action {drop | forward}]
28
383