Table of Contents
Advertisement
ACL Commands
mac access-group in
mac access-group in
mac access-list extended
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
switchxxxxxx(config-ipv6-acl)#
To bind a MAC-based ACL to an interface, use the mac access-group in Interface
Configuration mode command.
To remove all MAC-based ACLs from an interface, use the no form of this
command.
Syntax
acl-name
mac access-group
no mac access-group in
Parameters
acl-name
•
—Name of the MAC-based ACL. (Range: 1 to 32 characters)
Default Configuration
No MAC-based ACL is applied to the interface.
Command Mode
Interface Configuration (Ethernet) mode
Example
witchxxxxxx(config)# interface gi11
witchxxxxxx(config-if)# mac access-group macac11 in
To define a Layer 2 ACL based on source MAC address filtering and to enter the
MAC Access-List Configuration mode, use the mac access-list extended Global
Configuration mode command.
To remove a MAC-based ACL, use the no form of this command.
in
4
77
Advertisement
Table of Contents
