Ip Source Binding Max-Entry - Cisco 220 Series Smart Plus Reference Manual

IP Source Guard Commands

ip source binding max-entry

ip source binding max-entry
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
User Guidelines
A static IP source binding entry has an IP address, its associated MAC address,
and its associated VLAN number. The entry is based on the MAC address and the
VLAN number. If you modify an entry by changing only the IP address, the switch
updates the entry instead of creating a new one.
Example
switchxxxxxx(config)# ip source binding 00:aa:bb:cc:dd:ee vlan 7 192.168.1.50
interface fa1
switchxxxxxx(config)# ip source binding 00:bb:bb:cc:dd:ee vlan 7 192.168.1.60
interface gi1
switchxxxxxx(config)# ip source binding 00:cc:bb:cc:dd:ee vlan 10
192.168.1.90 interface po1
To set the maximum number of IP source binding rules on an interface, use the ip
source binding max-entry Interface Configuration mode command.
Syntax
ip source binding max-entry {
Parameters
• value —The maximum number of binding entries. (Range: 1 to 50)
• no-limit—Specifies no limit for this rule.
Default Configuration
The default is no limit.
Command Mode
Interface Configuration mode
Example
switchxxxxxx(config)# interface gi13
switchxxxxxx(config-if)# ip source binding max-entry 20
value
| no-limit}
17
265