Rate-Limit (Vlan) - Cisco 220 Series Smart Plus Reference Manual

QoS Commands

rate-limit (VLAN)

rate-limit (VLAN)
Cisco 220 Series Smart Plus Switches Command Line Interface Reference Guide Release 1.0.0.x
Example
The following example limits the incoming traffic rate on fa5 to 100000 kbps:
switchxxxxxx(config)# interface gi5
switchxxxxxx(config-if)# rate-limit 100000
To limit the incoming traffic rate for a VLAN, use the rate-limit VLAN Global
Configuration mode command.
To disable the rate limit for a VLAN, use the no form of this command.
Syntax
committed-rate
rate-limit
no rate-limit vlan vlan-id
Parameters
committed-rate
•
1000000)
vlan-id
• vlan —Specifies the VLAN ID.
Default Configuration
Rate limiting is disabled.
Command Mode
Global Configuration mode
User Guidelines
Traffic policing in a policy map takes precedence over the VLAN rate limiting. If a
packet is subject to traffic policing in a policy map and is associated with a VLAN
that is rate limited, the packet is counted only in the traffic policing of the policy
map.
vlan-id
vlan
—The average traffic rate (CIR) in kbps. (Range: 16 to
28
414