Configuring The Dmz Services - Cisco ISA500 Series Administration Manual

Wizards
Using the DMZ Wizard to Configure the DMZ Settings
STEP 5
STEP 6
NOTE
STEP 1
Cisco ISA500 Series Integrated Security Appliance Administrator Guide
• End IP: Enter the ending IP address of the DHCP pool.
The starting and ending IP addresses should be in the same range as
NOTE
the DMZ's subnet address.
• Lease Time: Enter the maximum connection time that a dynamic IP address
is "leased" to a network user. When the time elapses, the user is
automatically assigned a new dynamic IP address.
• DNS 1: Enter the IP address of the primary DNS server.
• DNS 2: Optionally, enter the IP address of a secondary DNS server.
• WINS 1: Enter the IP address for the primary WINS server.
• WINS 2: Optionally, enter the IP address of a secondary WINS server.
• Domain Name: Optionally, enter the domain name for the DMZ.
• Default Gateway: Enter the IP address of default gateway.
Click OK to save your settings.
Connect your local server to the specified DMZ port, and then configure the DMZ
service.

Configuring the DMZ Services

In the DMZ Service window, follow these procedures to configure the DMZ
services.
After you configure the DMZ services, the firewall access rules will automatically
generated by the security appliance to allow the access to the services on your
DMZ.
Click Add to create a DMZ service.
Other Options: To edit an entry, click Edit. To delete an entry, click Delete. To
delete multiple entries, check the boxes of multiple entries and click Delete
Selection.
2
49