Configuring A Range Of Interfaces - Cisco Catalyst 2960-XR Configuration Manual

Configuring a Range of Interfaces

DETAILED STEPS
Command or Action
Step 1
configure terminal
Example:
Switch# configure terminal
Step 2 interface interface-id
Example:
Switch(config)# interface gigabitethernet1/0/2
Step 3 description string
Example:
Switch(config-if)# description Connects to
Marketing
Step 4 end
Example:
Switch(config-if)# end
Step 5
show interfaces interface-id description
Configuring a Range of Interfaces
To configure multiple interfaces with the same configuration parameters, use the interface range global
configuration command. When you enter the interface-range configuration mode, all command parameters
that you enter are attributed to all interfaces within that range until you exit this mode.
SUMMARY STEPS
1. configure terminal
2. interface range {port-range | macro macro_name}
3. end
4. show interfaces [interface-id]
Catalyst 2960-XR Switch Interface and Hardware Component Configuration Guide, Cisco IOS Release 15.0(2)EX1
26
Configuring Interface Characteristics
Purpose
Enters global configuration mode.
Specifies the interface for which you are adding a
description, and enter interface configuration mode.
Adds a description (up to 240 characters) for an
interface.
Returns to privileged EXEC mode.
Verifies your entry.
OL-29420-01