Table of Contents
Advertisement
12-4 Updating the Software
The most recent version of the software and PC Tool can be downloaded from the following website for
OMRON members. Refer to the Member Registration Sheet that is enclosed with the Sensor.
http://www.omron-cxone.com/vision_sys
After you download the software, use the following procedure to update.
When you update the software, always update the software for the Touch Finder or PC Tool first, and then
update the software for the Sensor.
Step 1 Update the software for the PC Tool or Touch Finder.
• Update the PC Tool
Install the PC Tool that was downloaded.
• Update the software for the Touch Finder
1
Place the update file that you obtained directly in the root folder of an SD card.
2
Insert the SD card into the Touch Finder.
3
Press
(Setup Mode) - [TF settings] - [Update].
Step 2 Update the software for the Sensor.
• Updating from the PC Tool
1
Store the update file you obtained in the following directory.
\\....\My Documents\OMRON FQ\SDCard\UPDATE\SENSOR
2
To update the software in the Sensor, press
• Updating from the Touch Finder
1
Place the update file that you obtained directly in the root folder of the SD card.
2
Insert an SD card into the Touch Finder.
3
To update the software in the Sensor, press
The software will be updated automatically.
Important
Do not turn OFF the power supply until updating the software has been completed.
The Sensor or Touch Finder may not start normally if power is turned OFF during the update.
FQ2-S4 User's Manual
(Setup Mode) - [Sensor settings] - [Update].
(Setup Mode) - [Sensor settings] - [Update].
Updating the Software
569
Advertisement
Table of Contents
Troubleshooting
