Select The Results To Output; Reflect In Total Judgement - Omron FQ2-S4 User Manual

Select the Results to Output

You can use multiple conditions to determine which results to output from all the objects detected with a
correlation at the candidate level or higher.
Only the results that meet all the specified conditions are output.
[Inspect] − [Inspection] − [Search] − [Modify] − [Details] Tab Page − [Meas. Parameter]
1
Press [Extraction condition] and adjust the candi-
date level so that only objects higher than a certain
correlation are detected.
2
If [Multi-point output] is set to [Yes], you can specify
the output conditions for more than one result. (Ex-
traction X/Y and Detection count)
Extraction condi- Range
tion
Candidate level 0 to 100
−99999.9999 to 99999.9999
Extraction X
−99999.9999 to 99999.9999
Extraction Y
Detection count 1 to 32
Note
The processing time changes if you change the candidate level.

Reflect in Total Judgement

You can specify whether to reflect the judgement results of an inspection item in the overall judgement. (The
default is to reflect them.)
[Inspect] − [Inspection] − [Add item.] − [Search] − [Details] Tab Page − [Output parameter]
140
Inspecting with the Search Inspection Item
Description
Outputs only objects with a correlation that is higher
than the specified candidate level.
Results are output only for objects with a measured X
coordinate that is within this range.
Results are output only for objects with a measured Y
coordinate that is within this range.
Sets the maximum number of detection results to out-
put.
FQ2-S4 User's Manual