Omron FQ2-S4 User Manual page 74

Setting the Region to Filter
You can specify the region to which to apply the filter.
This setting does not exist in the Color Gray Filter item.
[Image] − [Image adjustment] − [Add filter] − (Filter item to select)
1 −
Press [ ]
2
Adjust the size and position of the region to which
the filter is to be applied.
To fine-tune the region, press [
right of the display to display the console. This will allow
you to change the coordinates of the rectangle at the pix-
el level.
Setting the Filter Type (for Color Gray Filter Only)
You can specify the ranges of colors to which the Color Gray Filter item is applied.
[Image] − [Image adjustment] − [Add filter] − [Color Gray Filter]
1 −
Press [ ]
2
Set the filter type to either [RGB] or [HSV].
Parameter
RGB (default)
HSV
3 −
Press [ ]
4
Make the detailed filter settings.
• RGB
Select the type of color filter to use.
If you select [Custom filter], set the gains for red, green,
and blue.
• HSV
Set the following ranges: [Std. Hue], [Hue range], and
[Chroma].
5
Press [OK].
6
Press [Back].
72
Adjusting the Images That Were Taken
[Filter region] on the right of the display.
−
]
[Filter type] on the right of the display.
Description
The red, green, and blue extraction ranges are
specified.
The extracted color ranges are specified with
the hue and chroma (saturation).
[Filter settings] on the right of the display.
Drag to move the region.
[Console] on the
Drag a corner to size the rectangle.
FQ2-S4 User's Manual