Omron FQ2-S4 User Manual page 185

Step 2 Teaching
Teaching means to store the region and the color area in the region as reference data for the measurement.
− [Inspection]
[Inspect]
1
Press [Teach].
2
Place the object that is to be used as the measure-
ment reference in front of the camera.
3
Move the rectangle to the location to be measured.
4
Press [OK].
5
Press [TEACH] on the lower right of the display.
The basic settings will be registered when teaching has
been completed. Areas with the extracted color will be
automatically detected.
Note
Information on the color that has the largest area in the measure-
ment region is extracted and registered. (The color information is
extracted only the first time.) The extracted color information will
not change from the second time on. To specify a desired color,
refer to Extraction Is Automatically Performed for an Undesired
Color When Teaching p. 184.
6
Press [Back] to end teaching.
Changing the measurement region: p. 144
The following data is stored as the measurement reference.
Item Parameter
Reference data Extract color
Reference area
Step 3 Adjusting Judgement Parameters
− [Inspection]
[Inspect]
1
Press [Judgement].
2
Press the parameters and set the range that is to be
judged as OK.
The measured value is displayed beside the parameter
name. Continuous measurements will be performed for
the images that are displayed.
Note
You can change the parameters for judgement conditions on the
Display Settings Display. Press
of the display to switch to the Display Settings Display.
3
Press [OK] to enter the value.
FQ2-S4 User's Manual
− [Add item.] − [Area] − [Settings] Tab Page
Description
This is the color for which to measure the area. The color occupying the larg-
est area will be automatically registered.
Setting Colors Manually: p. 184
The area to use as a reference is set automatically.
− [Add item.] − [Area] − [Settings] Tab Page
− [Display setting] on the right
[ ]
Drag the rectangle
Drag a corner to
to move it.
size the rectangle.
Lower limit
Upper limit
Blue for OK. Red for NG.
Inspecting with the Area Inspection Item
183