Measurement Data That Can Be Used For External Outputs And Calculations; Measurement Data That Can Be Logged (2D Code); Errors - Omron FQ2-S4 User Manual

Measurement Data That Can Be Used for External Outputs and Calculations

Expression text Data name
string
JG Judgment
IN Index
N Num. of characters

Measurement Data That Can Be Logged (2D Code)

The following values can be logged as measurement data.
Measured item Range of value
−2: No judgement (not measured),
Judgement
0: Judgement is OK,
−1: Judgement is NG,
−13: Teaching not performed error,
−14: Figure not registered error,
−15: Out of range error,
−16: Measurement timeout error
Num. of characters 0 to 1024
* When logging data is output, the data is output in the order of the above table.
7-6 Logging Measurement Data and Image Data: p. 252

Errors

Errors in Teaching
If 2D-codes cannot be read during an automatic registration, a teaching error message is displayed.
The reading may be unstable due to low contrast.Adjust the brightness to improve the contrast of the 2D-code.
Adjusting the Brightness: p. 61
FQ2-S4 User's Manual
Description
This is the judgment result.
The verification result (master data No.) is out-
put.
The number of characters read is output.
Description
This is the judgement result from the measurements.
The number of characters read is output.
Data range
−2: No judgment (not measured),
0: Judgment is OK,
1: Judgment is NG,
13: Teaching not performed error,
14: Figure not registered error,
15: Out of range error,
−16: Measurement timeout error
−2: Verification OFF, or reading error
−1: Verification is NG,
0 to 31: Master data No.
0 to 1024
Reading 2D-codes
127