Omron FQ2-S4 User Manual page 357

• Response Area
Signal name
FLG
BUSY
READY
OR
RUN
ERR
GATE
Command code
Response code
Response data
• Output Area
Signal name
Output data 1
Output data 8
● Accessing Communications Areas by Specifying I/O Memory Addresses
AT specifications can be set for variables to individually specify the I/O memory addresses that are assigned in
the communications areas.
1
Setting Tag Sets (Network Configurator)
Specify the tag names in the PLC directly by using the I/O memory addresses that are assigned in the
communications areas. (Output tags are specified for the input connections to the Sensor and input tags
are specified for output connections to the PLC.)
Setting Examples
Output tag: D0
Input tag: D100
2
Setting Variables (Sysmac Studio)
Define variables with AT specifications to the I/O memory addresses that are assigned in the communi-
cations areas as shown below.
Setting Examples
Variable: a (AT specification: D0.0)
Variable: b (AT specification: D0.1)
Variable: c (AT specification: D0.15)
Variable: d (AT specification: D1.0)
3
Setting Connections
Set the connections as shown in the following table.
Originator device (PLC) settings
Input tag set: D0
Output tag set: D100
FQ2-S4 User's Manual
Variable name
EIPInput.StatusFlag.F[0]
EIPInput.StatusFlag.F[1]
EIPInput.StatusFlag.F[2]
EIPInput.StatusFlag.F[3]
EIPInput.StatusFlag.F[4]
EIPInput.StatusFlag.F[15]
EIPInput.StatusFlag.F[16]
EIPInput.CommandCodeEcho
EIPInput.ResposeCode
EIPInput.ResposeData
Variable name
EIPInput.OutputData[0]
EIPInput.OutputData[7]
Target device (Sensor) settings
Output tag set: Input101
Input tag set: Output100
Outputting Data and Controlling Operation through EtherNet/IP
355