Increasing Processing Speed; Editing The Model Regions And Measurement Region - Omron FQ2-S4 User Manual

Increasing Processing Speed

The following two methods can be used to reduce processing time.
• Reduce the range in which a shape search II is performed for the model.
Changing the measurement region: p. 144
• Reduce the angle range setting.
Adjust the [Angle range] parameter to reduce the range in which a shape search II for the model is performed.
Setting the angle range: p. 141

Editing the Model Regions and Measurement Region

Changing the Model Regions
This section describes how to edit the model regions.
You can edit the model region in the same way as for a search region.
Changing the Model Registration Region to a Shape Other Than a Rectangle:
Important
If the model region is changed, perform teaching again.
p. 138
Changing the Measurement Region
The region within which the model is searched can be changed. In the default settings, the whole display is set
as the measurement region. You can edit the measurement region in the same way as for a search region.
Changing the Measurement Region:
152
Inspecting with the Shape Search II Inspection Item
Model registration region
Measurement region
(region that is searched for the model)
p. 144
p. 142
FQ2-S4 User's Manual