Exposure Start Trigger, Exposure End Trigger; Trigger Software - Omron STC-MBS312U3V Product Specifications And User's Manual

Exposure Start trigger determines exposure start timing, Exposure End trigger determines exposure end timing.
To operate the camera under this mode, the following settings have to be set.
・Exposure Mode: Trigger Controlled
・Selects Trigger Selector: Exposure Start, and Trigger Mode: On
・Selects Trigger Selector: Exposure End, and Trigger Mode: On
(*) On Trigger Mode except Frame Start should be set Off.
Timing
Trigger Input
ExposureStartトリガー
Trigger Input
ExposureStopトリガー
露光
Exposure
映像出力
Video Out
(*)When all of Trigger Mode (Frame Start trigger, Exposure Start trigger, Exposure End) are On, camera's behavior
depends on Exposure Mode setting.
When the Exposure Mode sets the Trigger Control, this function works through Trigger Start/End Trigger
This function works through Frame Start trigger for the remainder of the Exposure Mode.
Delay time on exposure start timing in the sensor Jitter (unit: μseconds
Video Output Format
8bits
10bits
10bits Packed
12bits
12bits Packed
This function can apply either external signal or a software command as the trigger.
The software trigger can be applied through the "execute Trigger Software" command when the trigger is
selected on the Trigger Selector.
STC-MBS312U3V / STC-MCS312U3V / STC-MBS500U3V / STC-MCS500U3V
Product Specifications and Use's Guide
For more information please contact Aegis Electronic Group, Inc. *(888)687-6877 *aegis-g2@aegiselect.com *http://www.aegiselect.com
(Positive)
I/O遅延(tIPDLH)
I/O Delay (tIPDLH)
(Negative)
LineDebounceTime
センサー内部の露光開始遅延
Exposure Start Duration
inside of sensor
I/O Delay (tIPDLH) I/O遅延(tIPDLH)
LineDebounceTime
TriggerDelay TriggerDelay
STC-MBS312U3V
STC-MCS312U3V
0 to 11.4
Exposure Start Duration
センサー内部の露光開始遅延
inside of sensor
)
STC-MBS500U3V
STC-MCS500U3V
0 to 13.4
No.16S024-02
33/64