Table of Contents
Advertisement
Menu command
Description
OUT0
Control
Used to assign output signals to OUT0,
to
signal
OUT1, and OUT2.
OUT2
Item
judge-
ment
Expres-
sion
judge-
ment
OR output
You can set the output conditions for the
OR signal and for output signals to which
judgements are assigned.
Output mode
You can set the output mode for the OR
signal and for output signals to which
judgements are assigned.
Output delay
When one-shot output mode is selected,
this parameter sets the delay from when
measurement processing is completed
until when the OR signal turns ON.
Output time
When one-shot output mode is selected,
this parameter sets the time that the OR
signal is ON.
BUSY output
Specifies when to turn OFF the BUSY
signal after starting measurement pro-
cessing.
OUT0 Polarity
You can change the polarity of the output
signals that are assigned to OUT0 to
OUT1 Polarity
OUT2 (regardless of what signal is
assigned to the output).
OUT2 Polarity
BUSY LED
You can change the BUSY indicator to a
RUN indicator.
Output control
You can select the data output method.
(Only when the FQ-SDU1@ is con-
nected.)
FQ2-S4 User's Manual
Setting range
OR (Total judgement) (default), BUSY,
ERROR, READY, RUN, STG
OR0 (Item0 judgement) to OR31 (Item31
judgement)
Exp.0 judgement to EXP. 31 judgement
OK: ON or NG: ON (default)
One-shot output, Level output (default)
0 to 1,000 ms (default: 0 ms)
1 to 1,000 ms (default: 5 ms)
Measurement (default), Data logging,
Image logging, or Result display
Positive (default), Negative
Positive (default), Negative
Positive (default), Negative
BUSY (default), RUN
None (default), Handshaking, or Sync.
Output
Data
Refer-
ence
System
p. 288
System
p. 290
System
p. 288
System
System
System
p. 291
System
p. 291
System
System
System
p. 278
System
p. 309
475
Menu Tables
Advertisement
Table of Contents
Troubleshooting
