Restarting And Shutting Down The Stm - NETGEAR STM150 Appliance Reference Manual

ProSecure Web/Email Security Threat Management (STM) Appliance Reference Manual

Restarting and Shutting Down the STM

You can perform a remote restart, for example, when the STM seems to have become unstable or
is not operating normally.
Note: Restarting will break any existing connections either to the UTM25 (such as your
management session) or through the UTM25 (for example, LAN users accessing
the Internet). However, connections to the Internet will automatically be re-
established when possible.
To restart the STM:
1. Locate the Restart & Shutdown section on the Diagnostics screen (this section is now shown
on any of the Diagnostics screen figures in this manual).
2. Click the Restart button. The STM restarts. (If you can see the unit: the reboot process is
complete when the Test LED on the front panel goes off.)
Note: See also
Note: For the STM150 only, there is an alternate way to restart: press the Power button on
the rear panel of the STM150 (see
panel Test LED flashes and the STM150 reboots.
To shut down the STM:
1. Locate the Restart & Shutdown section on the Diagnostics screen (this section is now shown
on any of the Diagnostics screen figures in this manual).
2. Click the Shutdown button. The STM shuts down.
Note: You can shut down the STM using the Web Management Interface, but you cannot
start up the STM using the Web Management Interface.
Monitoring System Access and Performance
"Updating the Software" on page
v1.0, September 2009
3-18.
"Rear Panel STM150" on page 1-14). The front
6-45