NETGEAR STM150 Appliance Reference Manual page 52

ProSecure Web/Email Security Threat Management (STM) Appliance Reference Manual
Enter the settings as explained in
screen.
Note: After you have completed the steps in the Setup Wizard, you can make changes to
the Web security settings by selecting Web Security > Policy or Web Security >
HTTP/HTTPS > Malware Scan. The Malware Scan screen also lets you specify
HTML scanning and notification settings. For more information about these
settings, see
Table 2-4. Setup Wizard Step 5: Web Security Settings
Setting Description (or Subfield and Description)
Services to Scan
HTTP HTTP scanning is enabled by
default on standard service port 80.
HTTPS HTTPS scanning is disabled by
default.
FTP FTP scanning is enabled by default
on standard service port 21.
Scan Action
HTTP From the HTTP pull-down menu, specify one of the following actions when an infected Web file
or object is detected:
• Quarantine file. The Web file or object is removed and placed in the malware quarantine for
further research. In addition, and depending on the nature of the malware, a virus log entry or
spyware log entry is created.
• Delete file. This is the default setting. The Web file or object is deleted, and a log entry is
created.
• Log only. Only a log entry is created. The Web file or object is not deleted.
Select the Streaming checkbox to enable the STM to forward already scanned data parts of a
file to the destination. This method allows the user to experience more transparent Web
downloading.
2-18
Table 2-4 on page
"Configuring Web and Services Protection" on page
To disable HTTP scanning, deselect the corresponding
checkbox. You can change the standard service port or
add another port in the corresponding Ports to Scan field.
To enable HTTPS scanning, select the corresponding
checkbox. You can change the standard service port (port
443) or add another port in the corresponding Ports to
Scan field.
To disable FTP scanning, deselect the corresponding
checkbox. You can change the standard service port or
add another port in the corresponding Ports to Scan field.
Using the Setup Wizard to Provision the STM in Your Network
v1.0, September 2009
2-18, then click Next to go the following
4-23.