NETGEAR STM150 Appliance Reference Manual page 50

ProSecure Web/Email Security Threat Management (STM) Appliance Reference Manual
Table 2-3. Setup Wizard Step 4: Email Security Settings
Setting Description (or Subfield and Description)
Services to Scan
SMTP SMTP scanning is enabled by default on standard
service port 25.
POP3 POP3 scanning is enabled by default on standard
service port 110.
IMAP IMAP scanning is enabled by default on standard
service port 143.
Scan Action
SMTP From the SMTP pull-down menu, specify one of the following actions when an infected e-mail is
detected:
• Quarantine attachment. The e-mail is not blocked, but the attachment is removed and
placed in the malware quarantine for further research. In addition, and depending on the
nature of the malware, a virus log entry or spyware log entry is created.
• Delete attachment. The e-mail is not blocked, but the attachment is deleted, and a log entry
is created.
• Block infected email. This is the default setting. The e-mail is blocked, and a log entry is
created.
• Quarantine infected email. The e-mail is is placed in the malware quarantine for further
research. In addition, and depending on the nature of the malware, a virus log entry or
spyware log entry is created.
• Log only. Only a log entry is created. The e-mail is not blocked and the attachment is not
deleted.
POP3 From the POP3 pull-down menu, specify one of the following actions when an infected e-mail is
detected:
• Quarantine attachment. The e-mail is not blocked, but the attachment is removed and
placed in the malware quarantine for further research. In addition, and depending on the
nature of the malware, a virus log entry or spyware log entry is created.
• Delete attachment. This is the default setting. The e-mail is not blocked, but the attachment
is deleted, and a log entry is created.
• Log only. Only a log entry is created. The e-mail is not blocked and the attachment is not
deleted.
2-16 Using the Setup Wizard to Provision the STM in Your Network
v1.0, September 2009
To disable any of these services, deselect
the corresponding checkbox. You can
change the standard service port or add
another port in the corresponding Ports to
Scan field.