NETGEAR STM150 Appliance Reference Manual page 67

ProSecure Web/Email Security Threat Management (STM) Appliance Reference Manual
Figure 3-2 [STM300]
Figure 3-3 shows the Interface Speed & Duplex Settings section of the Network Settings
screen of the STM150.
Figure 3-3 [STM150]
2. Complete the fields and make your selections from the pull-down menus as explained in
Table 3-1.
Table 3-1. Network Settings
Setting Description (or Subfield and Description)
Management Interface Settings
System Name The name for the STM for purposes of identification and management. The default
name is the name of your model (STM150, STM300, or STM600).
IP Address Enter the IP address of the STM through which you will access the Web
Management Interface. The factory default IP address is 192.168.1.201.
Note: If you change the IP address of the STM while being connected through the
browser, you will be disconnected. You must then open a new connection to the new
IP address and log in again. For example, if you change the default IP address from
192.168.1.201 to 10.0.0.1, you must now enter https://10.0.0.1 in your browser to
reconnect to the Web Management Interface.
Performing Network and System Management
v1.0, September 2009
3-3