Viewing System Status - NETGEAR STM150 Appliance Reference Manual

ProSecure Web/Email Security Threat Management (STM) Appliance Reference Manual
3. Use the From pull-down menu to select the start date of the Web usage report (year, month,
date) and the To pull-down menu to select the end date of the report (year, month, date).
4. Click View. The STM generates a Web usage report.
The Web usage reports shows the following columns:
• TOP. The Web usage ranking.
• Category. The Web category, including spam sites and Web applications.
• Requests. The number of requests for the category.
• % of Requests. The percentage of requests for the category in relation to the total number
of Web requests.
• IPs. The number of IP addresses that request the category.
• % of IPs. The percentage of IP addresses that request the category in relation to the total
number of IP addresses.
• Blocked. Whether or not the category is blocked by the STM.

Viewing System Status

The System Status screen provides real-time information about the following components of the
STM:
• Firmware versions and update information of the STM, software versions and update
information of the components, license expiration dates for each type of license, and hardware
serial number.
• Management interface information.
• MAC addresses for the STM's interfaces.
To view the System Status screen click Monitoring > System Status.
displays the System Status screen of the STM600. The Interfaces section of the System Status
screen differ for STM300 and STM150 (see
Monitoring System Access and Performance
Table 6-8 on page
v1.0, September 2009
Figure 6-10 on page 6-20
6-21).
6-19