NETGEAR STM150 Appliance Reference Manual page 68

ProSecure Web/Email Security Threat Management (STM) Appliance Reference Manual
Table 3-1. Network Settings (continued)
Setting Description (or Subfield and Description)
Subnet Mask Enter the IP subnet mask. The subnet mask specifies the network number portion of
an IP address. The STM will automatically calculate the subnet mask based on the IP
address that you assign. Unless you are implementing subnetting, use
255.255.255.0 as the subnet mask (computed by the STM).
Gateway Enter the IP address of the gateway through which you will access the STM.
Address
Primary DNS Specify the IP address for the primary DNS server IP address.
Secondary DNS As an option , specify the IP address for the secondary DNS server IP address.
Interface Speed & Duplex Settings
These sections show for each interface the MAC address, and for each active interface the assigned
speed and duplex setting. The Set Speed/Duplex pull-down menu allows you to select the speed and
duplex setting for each active interface. To set the speed to 1000baseT duplex ("full"), select auto to let
the STM sense the speed automatically.
Note: MGMT stands for management interface.
MGMT
PAIR1 UPLINK
STM600
PAIR1 DOWNLINK
(see Figure 3-1
on page 3-2)
PAIR2 UPLINK
PAIR2 DOWNLINK
MGMT
STM300
UPLINK
( see Figure 3-2
on page 3-3)
DOWNLINK
LAN1
LAN2
LAN3
LAN4
STM150
WAN
(see Figure 3-3
on page 3-3)
3-4
From the Set Speed/Duplex pull-down menu, make one of the
following selections:
• auto. Speed autosensing This is the default setting.
• 10baseT/Half. Ethernet speed at half duplex.
• 10baseT/Full. Ethernet speed at full duplex.
• 100baseT/Half. Fast Ethernet speed at half duplex.
• 100baseT/Full. Fast Ethernet speed at full duplex.
From the Set Speed/Duplex pull-down menu, make one of the
following selections:
• auto. Speed autosensing This is the default setting.
• 10baseT/Half. Ethernet speed at half duplex.
• 10baseT/Full. Ethernet speed at full duplex.
• 100baseT/Half. Fast Ethernet speed at half duplex.
• 100baseT/Full. Fast Ethernet speed at full duplex.
From the Set Speed/Duplex pull-down menu, make one of the
following selections:
• auto. Speed autosensing. This is the default setting, which
will sense 1000BaseT speed at full duplex.
• 10baseT/Half. Ethernet speed at half duplex.
• 10baseT/Full. Ethernet speed at full duplex.
• 100baseT/Half. Fast Ethernet speed at half duplex.
• 100baseT/Full. Fast Ethernet speed at full duplex.
Note: All LAN interfaces share the same MAC address, speed,
and duplex mode.
Note: The STM150 does not provide a dedicated management
interface.
Performing Network and System Management
v1.0, September 2009