ProSecure Web/Email Security Threat Management (STM) Appliance Reference Manual
Front Panel STM300
Figure 1-3
shows the front panel ports and status (LEDs) of the STM300.
1) Console Port
Figure 1-3
From left to right, the STM300's front panel shows the following ports and status LEDs:
1. Console port. Port for connecting to an optional console terminal. The ports has a DB9 male
connector. The default baud rate is 9600 K. The pinouts are: (2) Tx, (3) Rx, (5) and (7) Gnd.
2. Power LED.
3. Status LED.
4. Hard drive (HDD) LED.
5. One non-functioning USB port: this port is included for future management enhancements.
The port is currently not operable on any STM model.
6. Dedicated management (Mgmt) Gigabit Ethernet port with an RJ-45 connector.
7. One uplink (WAN) Gigabit Ethernet port with an RJ-45 connector, left LED, and right LED.
8. One downlink (LAN) Gigabit Ethernet port with RJ-45 connectors, left LEDs, and right LED.
Note: All Gigabit Ethernet ports provide switched N-way, automatic speed-negotiating,
auto MDI/MDIX technology.
1-10
2) Power LED
6) Mgmt Port
3) Status LED
5) USB Port
4) HDD LED
v1.0, September 2009
7) Uplink LEDs
8) Downlink LEDs
8) Downlink Port
7) Uplink Port
Introduction