Panasonic FP0R User Manual page 29

FP0R User's Manual
LED
RUN (green)
PROG. (green)
ERROR/ALARM (red)
W Operation mode selector
Used to change the operation mode of the PLC.
Switch position
RUN (upward)
PROG. (downward)
When performing remote switching with the programming tool, the po-
sition of the operation mode selector and the actual operation mode
may differ. Verify the mode with the operation status LED. Otherwise,
restart the FP0R and set the operation mode using the operation mode
selector.
E USB port (5-pin Mini-B type)
Used to connect a programming tool.
Panasonic's USB cable CABMINIUSB5D or a commercial USB2.0 AB type
cable can be used.
To use the USB port, you must install the USB driver (see p. 93).
R TOOL port (RS232C)
Used to connect a programming tool.
Description
Lights when in RUN mode and indicates that the pro-
gram is being executed.
Flashes during forced input/output (RUN and PROG.
LEDs flash alternately).
Lights when in PROG mode and indicates that operation
has stopped.
Flashes during forced input/output (RUN and PROG.
LEDs flash alternately).
Flashes when an error is detected by the self-diagnostic
function (ERROR).
Lights if a hardware error occurs, or if operation slows
because of the program, and the watchdog timer is
activated (ALARM).
Operation mode
Sets RUN mode. The program is executed and opera-
tion begins.
Sets PROG mode. Operation stops. In this mode, pro-
gramming via the TOOL port is possible.
CPU types
29