Setting Communication Parameters - Panasonic FP0R User Manual

Communication
E x a m p l e
Panasonic PLCs available for PLC Link

6.7.1 Setting communication parameters

142
Link flag L0 for station #1 turns to TRUE. The status change is fed back to
the programs of the other stations, and Y0 of the other stations is set to
TRUE. A constant of 100 is written to link register LD0 of station #1. The
contents of LD0 in the other stations are also changed to a constant of
100.
PLC Link connection between four FP0R units
# Station number of PLC LD Link register
FP0R (RS485 type)

FP7 (using RS485 type communication cassette)

FP (using RS485 type communication cassette)

FP-X (using RS485 type communication cassette)

 FP2-MCU (using RS485 type communication cassette)
Make the following settings for the communication port:
communication mode (PLC Link)

 station number
link area

For details on setting the communication parameters, see "Setting system
registers in PROG mode" on p. 102. For details on setting the link area, see
"Link area allocation" on p. 144.
FP0R User's Manual