Kyocera KM-C2525E Service Manual page 95

Maintenance
item No.
Setting the presence or absence of the coin vender
U206
Description
Sets the presence or absence of the optional coin vender. Also sets the details for coin vender operation, such
as mode and unit price.
This is an optional device which is currently supported only by Japanese specification machines, so no setting
is necessary.
Checking the operation panel keys
U207
Description
Checks operation of the operation panel keys.
Purpose
To check operation of all the keys and LEDs on the operation panel.
Method
1. Press the start key. The screen for executing is displayed.
2. COUNT1 is displayed and the leftmost LED on the operation panel lights.
3. As the keys lined up in the same line as the lit indicator are pressed in the order from the top to the bot-
tom, the figure shown on the touch panel increases in increments of 1.
When all the keys in that line are pressed and if there are any LEDs corresponding to the keys in the line
on the immediate right, the top LED in that line will light.
4. When all the keys on the operation panel have been pressed, all the LEDs light for up to 10 seconds.
5. When the LEDs go off, press the start key. All the LEDs light for 10 seconds again.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
Setting the paper size for the paper feeder
U208
Description
Sets the size of paper used in optional 3000-sheet paper feeder.
Purpose
To change the setting when installing the optional 3000-sheet paper feeder or the size of paper used in the
paper feeder is changed.
Setting
1. Press the start key.
2. Select the paper size (A4, B5 or 11 x 8.5).
Initial setting: 11 x 8.5 (Inch specifications)
A4 (Metric specifications)
3. Press the start key. The setting is set.
Completion
Press the stop/clear key. The screen for selecting a maintenance item No. is displayed.
Setting punch destination
U234
Description
Sets the destination of optional punch unit of 3000-sheet document finisher.
Purpose
To be set when installing a different punch unit from the destination of the machine.
Setting
1. Press the start key.
2. Select the destination.
Display
NOTHING
JAPAN METRIC
INCH
EUROPE METRIC
Initial setting: NOTHING
3. Press the start key. The setting is set.
4. Turn the main power switch off and on.
Description
Description
With no punch unit
Metric (Japan) specifications
Inch (North America) specifications
Metric (Europe) specifications
2JL/2JJ/2JG/2JD-1
1-3-55