Kyocera KM-C2525E Service Manual page 54

2JL/2JJ/2JG/2JD-1
Maintenance
item No.
U034 When [Timing B/W] is selected. (This setting is displayed by 40/35 ppm model only.)
Display
MPT (Large) BW
MPT (Small) BW
Cassette (Lrg)BW
Cassette (Sml)BW
Large size: 218 mm or more in width of paper.
3. Press the interrupt key.
4. Press the start key to output a test pattern.
5. Change the setting value using the cursor up/down keys.
For output example 1, increase the value. For output example 2, decrease the value.
6. Press the start key. The value is set.
Remark
When changing the setting value of [Large] each item is modified, equal to amount of the value which is
changed adds also the value of [Small] each item and is pulled.
Caution
Check the copy image after the adjustment. If the image is still incorrect, perform the following adjustments in
maintenance mode.
U034
Adjustment: Center line adjustment
1. Select the item.
Display
Center (MPT)
Center (Feed 1)
Center (Feed 2)
Center (Feed 3)
Center (Feed 4)
Center (Duplex)
2. Press the interrupt key.
3. Press the start key to output a test pattern.
1-3-14
Description
Paper feed from MP tray
Paper feed from MP tray
Paper feed from cassette
Paper feed from cassette
Leading edge registration
Correct image
U066 U071
(P.1-3-23) (P.1-3-27)
Description
Paper feed from MP tray
Paper feed from cassette 1
Paper feed from cassette 2
Paper feed from optional cassette 3
Paper feed from optional cassette 4
Duplex mode (second)
Description
Setting
range
-3.0 to 3.0
-3.0 to 3.0
-3.0 to 3.0
-3.0 to 3.0
Output Output
example 1 example 2
Figure 1-3-1
Setting
range
-3.0 to 3.0
-3.0 to 3.0
-3.0 to 3.0
-3.0 to 3.0
-3.0 to 3.0
-3.0 to 3.0
Default Change in
setting value per step
0 0.1 mm
0 0.1 mm
0 0.1 mm
0 0.1 mm
Default Change in
setting value per step
0 0.1 mm
0 0.1 mm
0 0.1 mm
0 0.1 mm
0 0.1 mm
0 0.1 mm