Kyocera KM-C2525E Service Manual page 167

Detailed settings
Perform more detailed correction.
1. Press [Color Regist.] ([Colour Regist.]).
2. Use numeric keys to enter the 4 digit management
code.
The default setting is 2500 for the 25/25 ppm
model, 3200 for the 32/25 and 32/32 ppm models
and 4000 for the 40/35 ppm model.
If the optional security kit has been installed, the
default setting is 25002500 for the 25/25 ppm
model, 32003200 for the 32/25 and 32/32 ppm
models and 40004000 for the 40/35 ppm model.
3. Press [Configuration].
4. Press [PrintChart (Details)].
5. A chart is printed. On the chart, for each of M
(magenta), C (cyan) and Y (yellow), charts for H-1
to 7 (upper) and V-1 to 5 (lower) are printed.
6. Find the location on each chart where 2 lines most
closely match. If this is the 0 position, registration
for that color is not required.
For the illustration, B is the appropriate value.
From the V-1 to 5 chart, read only the value for V-3
(the middle value).
7. Press [InputValue (Details)].
8. Press [+] or [-] to enter the value for H-1 from the
chart for each of M (magenta), C (cyan) and Y (yel-
low).
Press [+] to increase the value from 0 to 9. To
decrease, press [-].
By pressing [-], the value changes from 0 to alpha-
betic letters, going from A to I. To move in the
reverse direction, press [+].
9. Press [Next] to continue entering the values for H-2
to H-7, and V-3.
Press [Back] to return to the previous screen and
reenter the values.
10. Press [Completed.].
11. Color registration begins.
12. Press [Close].
Drum refresh
Refresh the drum when printed images are blurred or
white spots appear on the image.
1. Press [Drum refresh].
2. Press [On].
3. Drum refresh begins. The process takes approx.
100 seconds.
4. Press [Close].
Developer refresh
When the printing is too light or incomplete, even though
there is enough toner, refresh the developer.
1. Press [Developer refresh].
2. Use numeric keys to enter the 4 digit management
code.
The default setting is 2500 for the 25/25 ppm
model, 3200 for the 32/25 and 32/32 ppm models
and 4000 for the 40/35 ppm model.
If the optional security kit has been installed, the
default setting is 25002500 for the 25/25 ppm
model, 32003200 for the 32/25 and 32/32 ppm
models and 40004000 for the 40/35 ppm model.
3. Press [On].
4. Developer refresh begins. The process takes
approx. 140 seconds.
Waiting time may be longer when the toner is
refilled during developer refresh.
5. Press [Close]
Laser scanner cleaning
If the white or color streaks appear on images, perform
Laser Scanner Cleaning.
1. Press [Laser Scan Cleaning].
2. Press [On].
3. Laser scanner cleaning begins. The process takes
approx. 10 seconds.
4. Press [Close].
2JL/2JJ/2JG/2JD-1
1-3-127