Kyocera KM-C2525E Service Manual page 162

2JL/2JJ/2JG/2JD-1
RAM disk size setting
Specify the amount of memory from this device total
memory to allocate to the RAM disk. Enabling this func-
tion allows the use of electronic sorting and decreasing
total printing time.
Set the RAM Disk data size after setting RAM Disk mode
to [On].
1. Press [RAM DISK Mode].
2. Press [RAM Disk Size].
3. Press [+] or [-] to set the RAM Disk size.
The maximum size that can be allocated is the
amount of total memory minus 36 MB.
4. Press [Close].
5. If the memory size has been changed, press [Yes].
6. This device restarts.
Hard disk operation
The following hard disk operations become available
after installing the optional hard disk.
• Write Data
• Print List of Partitions
• Read Data (data, programs)
• Delete Data (data, fonts, programs, or macros)
• Hard Disk Format (Initialization)
Hard disk usage steps are the same as the memory card
usage steps.
Hard disk format (initialization)
Hard disk formatting (initialization) must be performed
when the hard disk is first installed to the printer.
1. Press [Hard Disk].
2. Press [Format].
3. Press [Yes].
4. Hard disk formatting begins.
Form feed timeout
After receiving the last data from the computer, and if no
response is received from the computer indicating the
data transmission has ended, this device will wait a pre-
determined time before printing the last page. After this
predetermined time, the page will be fed automatically.
Set the form feed timeout to `0' to prevent form feed until
[GO] is pressed manually.
1. Press [Others].
2. Select [Form Feed Time Out] using the cursor up/
down keys and press [Change #].
3. Press [+] or [-] to set the form feed wait time.
4. Press [Close].
1-3-122
Setting resource protect mode
When this device's emulation switches from PCL 6 to
another emulation type, all downloaded fonts and macros
are lost. Set the Resource Protect Mode to Protect or
Permanent to protect the PCL environment and preserve
those resources for use when again returning to PCL 6
emulation.
1. Press [Others].
2. Select [Resource Protect] using the cursor up/down
keys and press [Change #].
3. Press [Off], [Permanent] or [Permanent/Tempo-
rary].
4. Press [Close].
Auto continue
When an error occurs, automatically continues printing
from the next received data after the specified period of
time.
Auto continue can continue printing after the following
errors.
• [Print Overrun Press GO.]
• [Memory overflow Press GO.]
Also, specify the time delay before Auto continue.
1. Press [Others].
2. Select [Auto Continue] using the cursor up/down
keys and press [Change #].
3. Press [On] or [Off].
If [On] is pressed, press [+] or [-] to set the Auto
Continue delay time.
4. Press [Close].
Setting stapling error detection
Set whether to show an error message during stapling
when the staple supply is exhausted.
1. Press [Others].
2. Select [Finishing Error] using the cursor up/down
keys and press [Change #].
3. Select [Staple Mode] using the cursor up/down
keys and press [Change #].
4. Press [On] or [Off].
5. Press [Close].
Setting duplex mode printing error detection
For duplex mode printing, set whether to detect the paper
size and type and show an error message for paper that
does not support duplex printing.
1. Press [Others].
2. Select [Finishing Error] using the cursor up/down
keys and press [Change #].
3. Select [Proces. Duplex Print] using the cursor up/
down keys and press [Change #].
4. Press [On] or [Off].
5. Press [Close].