Kyocera KM-C2525E Service Manual page 235

Removing the paper feed pulley
7. Remove two stop rings from the primary
paper feed unit.
8. Pull the paper feed shaft in the direction of
the arrow and remove the paper feed pulley.
Removing the separation pulley
9. Remove the stop ring from the primary
paper feed unit.
10. Pull the separation shaft in the direction of
the arrow and remove the separation pulley.
11. Clean or replace the forwarding, paper feed
and separation pulleys.
12. Install the separation and paper feed pulleys
to the primary paper feed unit.
13. Install the forwarding pulley to the forward-
ing pulley retainer.
When refitting the forwarding pulley, orient it
correctly as shown in Figure 1-5-6.
14. Refit the forwarding pulley retainer to the pri-
mary paper feed unit.
15. Refit the primary paper feed unit.
16. When the forwarding pulley, paper feed pul-
ley, separation pulley or the primary paper
feed unit is replaced, perform maintenance
mode U903 to clear the jam counter (see
page 1-3-95).
Stop ring
Paper feed shaft
Paper feed pulley
Figure 1-5-4
Separation shaft
Stop ring
Figure 1-5-5
Machine front
Forwarding pulley
Figure 1-5-6
2JL/2JJ/2JG/2JD
Stop ring
Separation pulley
Machine rear
1-5-3