Removing The Standard Ps - Fujitsu PRIMERGY TX300 S4 Options Manual

Removing the standard PS

12.1 Removing the standard PS
Ê Open the server as described in the
seq..
Ê Remove the system fan (see on
Figure 82: Removing the fan guide
Ê Unlock the snap-fit (1).
Ê Push the fan guide in direction of the arrow (2) and take it out.
Ê Disconnect all power cables from the system board and the drives (see the
cabling plans in the Appendix).
96
Conversion standard PS to hot-plug PS
chapter "Preparation" on page 21
page 29).
1
2
Options Guide
et
TX300 S4