Fujitsu PRIMERGY TX300 S4 Options Manual page 16

Before starting up
V
CAUTION!
During installation and before operating the device, observe the
instructions on environmental conditions for your device.
If the device is brought in from a cold environment, condensation may
form both inside and on the outside of the device.
Wait until the device has acclimatized to room temperature and is
absolutely dry before starting it up. Material damage may be caused
to the device if this requirement is not observed.
Transport the device only in the original packaging or in packaging
that protects it from knocks and jolts.
Installation and operation
V
CAUTION!
This unit should not be operated in ambient temperatures above
35 °C.
If the unit is integrated into an installation that draws power from an
industrial power supply network with an IEC309 connector, the power
supply's fuse protection must comply with the requirements for non-
industrial power supply networks for type A connectors.
The unit automatically adjusts itself to a mains voltage in a range of
Wert. Ensure that the local mains voltage lies within these limits.
This device must only be connected to properly grounded shock-
proof sockets or insulated sockets of the rack's internal power supply
with tested and approved power cables.
Ensure that the device is connected to a grounded shockproof socket
close to the device.
16 Options Guide
Safety instructions
TX300 S4