Fujitsu PRIMERGY TX300 S4 Options Manual page 82

Replacing the processor
Figure 71: Inserting a new processor
Ê Position the new processor over the socket and then carefully press it into
the socket (1).
V
CAUTION!
The processor can only be installed in one particular direction. Note
the marking on one of the corners. To avoid damaging the pins or the
processor, do not force it into the socket.
Ê Close the cover (2).
Ê Lock the processor in place in the socket by returning the socket lever to its
original position (3).
Ê Apply a small amount of thermal paste to the upper side of the new
processor.
Ê Ensure a thin and even distribution of the thermal paste.
Ê Place the heat sink on the processor socket (see on
Ê Fasten the heat sink by tightening the four screws in a crossover pattern.
Ê Reinstall the system fan (see on
Ê Reinstall the heat sink holder (see on
Ê Reinstall the air duct (see on
Ê Close the server, connect it to the power outlet, and switch it on as described
on page 118 for the floorstand model or on
82
2
3
1
page 113).
page 79)
page 115).
page 120
Options Guide
Processors
page 78).
for the rack model.
TX300 S4