Parallel interface
Figure 74: Cabling the parallel interface
Ê Connect the parallel interface cable to the system board (connector is
labeled PARALLEL PORT).
Ê Fold the cable as shown and route it closely to the PS separation wall.
Ê Reinstall the secondary memory riser card (see on
Ê Reinstall the air duct (see on
Ê Close the server, connect it to the power outlet, and switch it on as described
on
page 118
for the floorstand model or on
TX300 S4
Installing a parallel interface
page
115).
page 120
Options Guide
page
37).
for the rack model.
87