Fujitsu PRIMERGY TX300 S4 Options Manual page 42

Installing an accessible 5.25-inch drive
Figure 23: Attaching the EasyClick rails - DVD drive
Ê Screw the EasyClick rails onto either side using two M3 x 4.5 mm screws (1).
Use the first hole in each upper row of holes as shown in the figure.
I
Keep the remaining screws for future use. The different drives are
fastened using different screws. Starting on the next page, you will
find figures which show the attaching of the EasyClick rails for
magnetic tape drives.
Ê Push the new drive about halfway into the bay.
Ê Connect the data cable to the accessible drive (see the cabling plans in the
Appendix).
Ê Connect the power cable to the accessible drive (see the cabling plans in the
Appendix).
Ê Push the drive fully into the bay until the EasyClick rails lock in place.
Ê Attach the front cover or rack front cover, close the server, connect it to the
power outlet, and switch it on as described in the
on page 116 or
42
1
section "Rack model" on page
Options Guide
Accessible drives
1
section "Floorstand model"
119.
TX300 S4